Abaqus Volume II: I–Z Manual de usuario descargar pdf (Pagina 187)

100

101

NCOPY

2. Y-coordinate of the ﬁrst poi nt deﬁnin g the reﬂection plane.

3. Z-coordinate of the ﬁrst point deﬁning the reﬂection plane.

4. X-coordinate of the second point deﬁning the reﬂ ection plane (point b in Figure 14.1–3).

5. Y-coordinate of the second point deﬁnin g the reﬂection plane.

6. Z-coordinate of the second point deﬁning the re ﬂection plane.

Second line:

1. X-coordinate of the third point deﬁning the reﬂection plane (point c in Figure 14.1–3) .

2. Y-coordinate of the third point deﬁning the re ﬂection plane.

3. Z-coordinate of the third point deﬁning the re ﬂection plane.

Data line if REFLECT=POINT:

First (and only) line:

1. X-coordinate of the reﬂection point (point a in Figure 14.1– 4).

2. Y-coordinate of the reﬂection point.

3. Z-coordinate of the reﬂection point.

Data line if the POLE parameter is included:

First (and only) line:

1. Number of the pol e node (optional: it must ha ve been deﬁned already).

2. X-coordinate of the pole node (point a in Figure 14.1–5, only required if the pole node number

was not entered).

3. Y-coordinate of the pole node (only required if the pole node number was not entered).

4. Z-coordinate of the pole node (only required if the pole node numbe r was not entered).

14.1–3

ABAQUS Version 6.1 Module:

ID:

Printed on:

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 627 628

Abaqus Volume II: I–Z Manual de usuario Pagina 187

Comentarios a estos manuales